Siemens SIRIUS M200D - Response to Switching Element Supply Voltage Cut-Off

Functions
3.3 Basic functions / parameters
M200D PROFIBUS/PROFINET
30 Manual, 08/2014, A5E01577426A/RS-AA/004
3.3.4
Response to switching element supply voltage cut-off
With this parameter, you determine which message the motor starter is to output if the
supply voltage of the switching elements fails.
Note
Supply voltage of the switching elements
The supply voltage of the switching elements (24 V) must be applied via the auxiliary voltage
connections (7/8").
Settings
Device parameter
Default setting
Setting range
Response to switching element supply
voltage cut-off
Group fault
• Group fault
• Group fault only after ON
command
• Group warning