Siemens SIRIUS M200D - Group Diagnostics

Functions
3.4 Fieldbus interface
M200D PROFIBUS/PROFINET
32 Manual, 08/2014, A5E01577426A/RS-AA/004
Settings
Device parameter
Default setting
Setting range
Response to CPU/master STOP Switch substitute value
• Switch substitute value
• Retain last value
Substitute value 0 8 x (0 or 1)
Messages and actions
Message
Action
CPU/master STOP Dependent on parameterization
Bus error "Response to CPU/master STOP" depending on parameterization
3.4.2
Group diagnostics
With this parameter, you specify whether diagnostics via the fieldbus interface is to be
enabled or blocked. If group diagnostics is parameterized as "block", no error messages are
transmitted.
Settings
Device parameter
Default setting
Setting range
Group diagnostics block
• block
• enable