Siemens SIRIUS M200D - Page 61

Functions
3.7 System monitoring
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
61
Settings
Device parameter
Default setting
Setting range
Output level 1 Not inverted
• Not inverted
• Inverted
Output level 2
Output 1 signal Continuous signal
• Continuous signal
• Flashing
Output 2 signal
Output 1 action Control source
PIO DO 1.0
Triggering by means of external control source
• Control source PIO DO 1.0
(output 1)
• Control source PIO DO 1.1
(output 2)
• Control source PIO DO 0.2
1)
(brake output)
• Control source input 1
• Control source input 2
• Control source input 3
• Control source input 4
Actuation by motor starter
• Run-up
2)
• Operation/shunting
2)
• Coasting down
2)
• On time motor (RUN)
• Control command motor ON
• Brake output
• Device ON
Actuation by messages from the motor starter
• Group prewarning
• Group warning
• Group fault
• Bus error
• Device error
• Maintenance required
• Maintenance requested
• Ready for motor ON
Output 2 action Control source
PIO DO 1.1
1) Brake output only on starters with BO
2) Run-up, operation/shunting, coasting down only on soft starters.
Messages and actions
Message
Action
Output 1 active The output is controlled
Output overloaded Tripping (acknowledgment via trip reset)
Output BO (brake output) active The brake output is controlled