Appendix
A.1 Data formats and data sets
M200D PROFIBUS/PROFINET
200 Manual, 08/2014, A5E01577426A/RS-AA/004
The supported object numbers and their meaning are shown in the table below:
1419 ± Prewarning limit - remaining time for tripping undershot
1420 ± Prewarning limit - motor heating exceeded
1457 ± Maintenance required
324 ± Temperature sensor overload
325 ± Temperature sensor wire break
326 ± Temperature sensor short-circuit
327 ± Thermal motor model overload
333 ± Circuit breaker tripped
334 ± I
e
upper limit violation
335 ± I
e
lower limit violation
337 ± Residual current detected
340 ± Asymmetry detected
351 ± Input warning
318 ± No switching element supply voltage
1486 ± Connector disconnected on line side
1458 ± Maintenance requirement
310 ± Emergency start active
357 Automatic mode
358 Manual mode bus
1443 Manual bus - PC controls
359 Manual local mode
1444 Manual local - input controls
1445 Manual local - HMI controls
1446 Manual local - PC controls
360 ± Manual operation connection abort
363 Maximum pointer deleted
365 Invalid parameter value
366 Parameters cannot be changed in ON state
368 ± Parameters disabled CPU/master active
369 Factory settings restored
1422 ± Thermal motor model deactivated
1484 ± Temperature sensor deactivated
1302 Logbook - Triggering operations deleted
1303 Logbook - Events deleted
1520 ± Energy-saving mode active
±: Event is entered as "incoming" (+) and "outgoing" (-) event. Other messages are entered only as
"incoming" messages
To Next Page
Loading...
