Functions
3.11 Trace functions
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
73
Channel x signal type (x = 1 to 4)
It is possible to record up to 4 signals. These 4 parameters enable separate selection of
subsequent signals or events for each of the four recording channels.
● No signal (= deactivated)
● Phase current I
L1(rms)
to I
L3(rms)
● Asymmetry
● Motor heating
● Input IN1 to IN4
● Output OUT1/OUT2
● Heat sink temperature
● Phase current I
Lmax(rms)
● Output bypass
Trace recording in progress -
Trigger event occurred -
Trace recording stopped -
Trace memory deleted -
To Next Page
Loading...
