Siemens SITRANS LUT400 - Application Examples; Change History; Sensor Node; Lui

Introduction
1.2 Change History
SITRANS LUT400
14 Operating Instructions, 07/2019, A5E33329501-AC
1.1.2 Application examples
The application examples used in this manual illustrate typical installations using SITRANS
LUT400. As there is often a range of ways to approach an application, other configurations
may also apply.
In all examples, substitute your own application details. If the examples do not apply to your
application, check the applicable parameter reference for the available options.
1.2 Change History
1.2.1 Sensor node
Firmware
Rev.
PDM EDD
Rev.
Date
Changes
1.00.00 1.00.00 August 3,
2012
• Initial release.
1.00.01 1.00.01 October 1,
2012
• Totalizers values are maintained over a power loss.
• Alarms now trip at or beyond setpoints, instead of just
beyond.
• Alarm log files now contain values in user-selected
units. Those units are also logged into files.
• OCM Totalizer values that appear in data log files
now in flow units.
1.01.00
1.01.00
June 1, 2013
• Added ’mega-gallons per day’ flow unit.
1.01.01 1.01.01 February 1,
2014
Added Russian, Portuguese and Italian language sup-
port.
1.02.00 1.02.00 December 1,
2014
• Added user changeable password and First In, First
Out datalog option.
1.2.2 LUI
Firmware Rev.
Date
Changes
1.00.00
August 3, 2012
Initial release
1.01.00 June 1, 2013 • Level value or level units are now recorded for an in-bounds
level alarm in the alarm log.
• Correction of flow rate on exponential devices using absolute
calculation.
1.01.01
February 1, 2014
Added Russian, Portuguese and Italian language support.
1.02.00 December 1, 2014 Added user changeable password and First In, First Out data-
log option.