Connecting
5.1 Connecting SITRANS LUT400
SITRANS LUT400
34 Operating Instructions, 07/2019, A5E33329501-AC
5.1 Connecting SITRANS LUT400
• Check the device label on your instrument, to verify the approval rating.
• Use appropriate conduit seals to maintain IP or NEMA rating.
Note
Separate cables and conduits may be required to conform to standard instrumentation wiring
practices or electrical codes.
To access the wiring compartment:
1. Loosen 1/4 turn locking screws.
2. Lift lid up and to the left on its hinges.
3. The lid can remain open connected by hinges, or it can be unclipped from the hinges and
set to one side, to access wiring compartment.
4. Make all connections as per instructions that follow.
5. When wiring complete, replace device lid.
6. Tighten locking screws.
To Next Page
Loading...
