Siemens SITRANS LUT400 - Setup (2.)

SITRANS LUT400
168 Operating Instructions, 07/2019, A5E33329501-AC
9.1 Wizards (1.)
Several Wizards are available with the SITRANS LUT400. Wizards group together all the
settings needed for a particular feature. All Wizards are available via the local push buttons,
and many are also available via SIMATIC PDM under the Device menu.
For details on the Wizards listed below, see Quick Start Wizards (Page 57) of
Commissioning.
QS Level (1.1.1.)
QS Volume (1.1.2.)
QS Flow (1.1.3.) Available only on LUT430 (Pump and Flow) and LUT440 (OCM) configured
models.
Pump control (1.2.)
9.2 Setup (2.)
Note
•
See Local Commissioning (Page 50) or Operation via SIMATIC PDM 6 (HART)
(Page 161) for instructions.
•
Default settings in the parameter tables are indicated with an asterisk (*) unless explicitly
stated.
•
Values shown in the following tables can be entered via the local push buttons.
9.2.1 Sensor (2.1)
9.2.1.1 Units (2.1.1.)
Determines sensor measurement units used when Sensor Mode (2.1.2.) (Page 168) set to
Level, Space, Distance, or Head.
Options
m, cm, mm, ft, in
Default: m
9.2.1.2 Sensor Mode (2.1.2.)
Menu number 2.1.2. visible on LUT420 (Level model).
OR