SITRANS LUT400
166 Operating Instructions, 07/2019, A5E33329501-AC
8.5.2 Startup and Configuration
To startup the SITRANS LUT400 using an FDT, you must first install the DTM (see below).
You can then configure the device using the parameters available with the FDT.
The full process to configure a field device via FDT is outlined in an application guide for
SITRANS DTM, which can be downloaded from the product page of our website. Go
to:www.siemens.com/sitransLUT400 (www.siemens.com/sitransLUT400
) under Support and
click on Application Guides.
8.5.2.1 Device Type Manager (DTM)
A DTM is a type of software that ’plugs into’ FDT. It contains the same information as an
EDD but an EDD is independent of the operating system.
8.5.2.2 SITRANS DTM version 3.1
● SITRANS DTM is an EDDL interpreter developed by Siemens to interpret the EDD for
that device.
● To use SITRANS DTM to connect to a device, you must first install SITRANS DTM on
your system and then install the instrument EDD written for SITRANS DTM.
● You can download SITRANS DTM from our website at:
http://www.siemens.com/sitransdtm (http://www.siemens.com/sitransdtm
).
Click on Support then go to Software downloads.
8.5.2.3 Electronic Device Description (EDD)
The SITRANS LUT400 HART EDD for SITRANS DTM can be downloaded from the product
page of our website.
Go to www.siemens.com/sitransLUT400 (www.siemens.com/sitransLUT400
) under Support
and click on Software Downloads.
To Next Page
Loading...
