Siemens SITRANS LUT400 - Measured Values (2.12.5.)

SITRANS LUT400
224 Operating Instructions, 07/2019, A5E33329501-AC
To use TVT shaper via local push buttons:
1. Navigate to Setup (2.) (Page 168) > Signal Processing (2.12.) (Page 218) > TVT Setup
(2.12.3.) (Page 221) > Shaper Mode (2.12.3.4.) (Page 223
), and select ON.
2. From the TVT Setup menu, LEFT ARROW to the Signal Processing menu, and DOWN
ARROW to TVT Shaper. RIGHT ARROW to enter the TVT Shaper menu and RIGHT
ARROW to edit Breakpoint 1-8 (2.12.4.1.) (Page 224).
3. Open TVT Breakpoint 1 enter the TVT Offset value (between –50 and 50).
4. Go to the next TVT Breakpoint and repeat steps c) and d) till all desired breakpoint values
have been entered.
1)
Communications for SITRANS LUT400 (HART) Manual (7ML19985NE01)
Breakpoint 1-8 (2.12.4.1.)
Values
Range: –50 to 50 dB
Default: 0 dB
Breakpoint 9-16 (2.12.4.2.)
Values
Range: –50 to 50 dB
Default: 0 dB
Breakpoint 17-24 (2.12.4.3.)
Values
Range: –50 to 50 dB
Default: 0 dB
Breakpoint 25-32 (2.12.4.4.)
Values
Range: –50 to 50 dB
Default: 0 dB
Breakpoint 33-40 (2.12.4.5.)
Values
Range: –50 to 50 dB
Default: 0 dB
9.2.12.5 Measured Values (2.12.5.)
Read only. Allows you to view measured values for diagnostic purposes.