Siemens SITRANS LUT400 - Page 313

SITRANS LUT400
Operating Instructions, 07/2019, A5E33329501-AC
311
2.7.1.8 ON SETPOINT PUMP 2
2.7.1.9 OFF SETPOINT PUMP 2
2.7.1.10 SERVICE RATIO PUMP 1
2.7.1.11 SERVICE RATIO PUMP 2
2.7.2 MODIFIERS
2.7.2.1 WALL CLING REDUCTION
2.7.2.1.1 ENABLE
2.7.2.1.2 LEVEL SETPOINT VARIATION
2.7.2.2 ENERGY SAVINGS (LUT430, 440 only)
2.7.2.2.1 ENABLE
2.7.2.2.2 PEAK LEAD TIME
2.7.2.2.3 PEAK 1 START TIME
2.7.2.2.4 PEAK 1 END TIME
2.7.2.2.5 PEAK 2 START TIME
2.7.2.2.6 PEAK 2 END TIME
2.7.2.2.7 PEAK 3 START TIME
2.7.2.2.8 PEAK 3 END TIME
2.7.2.2.9 PEAK 4 START TIME
2.7.2.2.10 PEAK 4 END TIME
2.7.2.2.11 PEAK 5 START TIME
2.7.2.2.12 PEAK 5 END TIME
2.7.2.2.13 PEAK ON SETPOINT PUMP 1
2.7.2.2.14 PEAK OFF SETPOINT PUMP 1
2.7.2.2.15 PEAK ON SETPOINT PUMP 2
2.7.2.2.16 PEAK OFF SETPOINT PUMP 2
2.7.2.3 PUMP RUN-ON (LUT430, 440 only)
2.7.2.3.1 ENABLE
2.7.2.3.2 RUN-ON INTERVAL
2.7.2.3.3 RUN-ON DURATION PUMP 1
2.7.2.3.4 RUN-ON DURATION PUMP 2
2.7.2.4 PUMP START DELAYS (LUT430, 440 only)
2.7.2.4.1 DELAY BETWEEN STARTS
2.7.2.4.2 POWER RESUMPTION DELAY
2.7.3 TOTALIZERS (LUT430, 440 only)
2.7.3.1 RUNNING TOTALIZER
2.7.3.2 TOTALIZER DECIMAL POSITION
2.7.3.3 TOTALIZER MULTIPLIER
2.7.3.4 INFLOW/DISCHARGE ADJUST
2.7.3.5 RESET RUNNING TOTALIZER
2.8 ALARMS
2.8.1 HIGH LEVEL ALARM