Siemens SITRANS LUT400 - Page 62

Commissioning
6.3 Quick Start Wizards
SITRANS LUT400
60 Operating Instructions, 07/2019, A5E33329501-AC
Start of QS Level Wizard
Note
The introduction screen is displayed only on the device when using
the local push buttons.
This screen is not part of the Quick Start when using SIMATIC PDM.
Shows the type of Wizard to be executed.
Options
CANCEL, START
Transducer
Specifies the Siemens transducer connected to the device.
Options NO TRANSDUCER, XRS-5, XPS-10, XPS-15, XCT-8, XCT-12, XPS-30, XPS-40,
XLT-30, XLT-60, STH
Default: NO TRANSDUCER
Operation
Sets the type of measurement (and the corresponding mA output) required for the
application.
①
Distance
②
Sensor reference point
③
High calibration point
④
Space
⑤
Level
⑥
Low calibration point
⑦
Far range