Modules And Accessories
3.101
ENET-710 – Modbus/CDBus TCP 10/100 Base-T Ethernet MODULE
(Supports Hot Swap)
Part Number
ENET-710 (Módulo Modbus/CDBus TCP 10/100 Base-T Ethernet)
Description
The ENET-710 is a data communication module that bridges Ethernet and Serial communication
networks. With the increasing importance of networking for industrial control/automation, the ENET-
710 module provides Ethernet-networked computers the ability to perform remote monitoring and
control of serial Modbus compatible industrial devices in the field as well as access to LC700 PLC
CPU modules and the CD600 Multi-Loop Controller.
The module can be installed in the LC700 Programmable Logic Controller (PLC) to receive power,
or it can be operated in a stand-alone fashion with an external +24VDC power source. There is also
a redundant power supply mode when using both power sources.
For more details about this module, see its equipment manual.
Figure 3.64 – ENET-710 Module
Technical Specifications
CONTROLLER
Type 8-bit
Program Memory Flash
NETWORK INTERFACE
Ethernet
IEEE 802.3 10Mbps 10BASE-T
IEEE 802.3u 100Mbps 100BASE-TX
Medium Category 5 or UTP
Protocols Modbus TCP, TCP/IP e HTTP
Open TCP connections Maximum of 7
Isolation 1500V
To Next Page
Loading...