SMAR LC700 - Rio-700-D3 - Remote I;O Communication Interface; Description; Adding a Remote I;O Unit

Modules And Accessories
3.23
RIO-700-D3 - Remote I/O Communication Interface
Part Number
RIO-700-D3 – Remote I/O Interface (Slave)
Description
Remote I/O modules are located close to the field devices and allow a flexible architecture to the
system. Remote I/O units use the same I/O modules designed for the regular LC700 system
combined with the RIO-700-D3 module.
This module must used together with CPU-700-D3 and CPU-700-D3R.
NOTE
The firmware update is made using Smar’s software LC700Tools.
Adding a remote I/O unit
To add a remote I/O system, first click on the Go to I/O module page, next click on Add/Delete
Remote I/O system. The following page will be showed.
Choose a remote I/O system and click on the corresponding button.
Warning
The address and baud rate of the RIO-700-D3 interface module must be set. Interface modules
and power supply modules for remote I/O are automatically set.