SMAR LC700 - Flat Cables Protector (Connector Cap); Installing the Imb Terminator - T-700 or Df96

LC700 – User’s Guide
2.6
Figure 2.8 - Ground terminal installed
Flat cables protector (connector cap)
To meet the EMC requirements a protector against ESD has to be installed on the flat cables
connection, at right. In the following figure a flat cable protector is shown when it is being installed
on the cable connector.
Figure 2.9 - Installing the connector cap
In the following figure is shown a connector cap installed.
Figure 2.10 - Connector cap installed
Installing the IMB terminator – T-700 or DF96
Only one of these two terminators types (T-700 or DF96) must to be installed at the end of IMB bus.
It will depend on which side the last rack is connected to the system.