C
ONFIGURING
THE
S
WITCH
2-86
Address Table Settings
Switches store the addresses for all known devices. This information is
used to route traffic directly between the inbound and outbound ports. All
the addresses learned by monitoring traffic are stored in the dynamic
address table. You can also manually configure static addresses that are
bound to a specific port.
Setting Static Addresses
A static address can be assigned to a specific interface on this switch. Static
addresses are bound to the assigned interface and will not be moved.
When a static address is seen on another interface, the address will be
ignored and will not be written to the address table.
Command Attributes
• Static Address Counts* – The number of manually configured
addresses.
• Current Static Address Table – Lists all the static addresses.
• Interface – Port or trunk associated with the device assigned a static
address.
• MAC Address – Physical address of a device mapped to this
interface.
• VLAN – ID of configured VLAN (1-4094).
* Web Only.
To Next Page
Loading...
Need help?
General
