F
LASH
/F
ILE
C
OMMANDS
3-21
• To replace the startup configuration, you must use startup-config as
the destination.
• The Boot ROM image cannot be uploaded or downloaded from the
TFTP server. You must use a direct console connection and access the
download menu during a boot up to download the Boot ROM (or
diagnostic) image. See “Upgrading Firmware via the the Serial Port” on
page B-1 for more details.
Example
The following example shows how to upload the configuration settings to
a file on the TFTP server:
The following example shows how to copy the running configuration to a
startup file.
The following example shows how to download a configuration file:
Console#copy file tftp
Choose file type:
1. config: 2. opcode: <1-2>: 1
Source file name: startup
TFTP server ip address: 10.1.0.99
Destination file name: startup.01
/
Console#
Console#copy running-config file
destination file name : startup
Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#
Console#copy tftp startup-config
TFTP server ip address: 10.1.0.99
Source configuration file name: startup.01
Startup configuration file name [startup]:
Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#
To Next Page
Loading...
