EasyManua.ls Logo

SMC Networks 6724AL2

SMC Networks 6724AL2
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SNMP C
OMMANDS
3-63
Example
Related Commands
snmp-server contact (3-63)
snmp-server host
Use this command to specify the recipient of a Simple Network
Management Protocol notification operation. Use the no form to remove
the specified host.
Syntax
snmp-server host {host-addr community-string} [version 1 | 2c]
no snmp-server host host-addr
host-addr - Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
community-string - Password-like community string sent with the
notification operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you
define this string using the snmp-server community command
prior to using the snmp-server host command. (Maximum
length: 32 characters)
version - Specifies whether to send notifications as SNMP v1 or
SNMP v2c traps.
Default Setting
Host Address: None
SNMP Version: 1
Command Mode
Global Configuration
Command Usage
If you do not enter an snmp-server host command, no
Console(config)#snmp-server location WC-19
Console(config)#

Table of Contents

Related product manuals