EasyManua.ls Logo

SMC Networks 6724AL2

SMC Networks 6724AL2
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
I
NTERFACE
C
OMMANDS
3-89
Example
The following example configures port 11 to use autonegotiation.
Related Commands
negotiation (3-89)
speed-duplex (3-88)
capabilities
Use this command to advertise the port capabilities of a given interface
during autonegotiation. Use the no form with parameters to remove an
advertised capability, or the no form without parameters to restore the
default values.
Syntax
capabilities {1000full | 100full | 100half | 10full | 10half |
flowcontrol | symmetric}
no capabilities [1000full | 100full | 100half | 10full |
10half | flowcontrol | symmetric]
1000full - Supports 1000 Mbps full-duplex operation
100full - Supports 100 Mbps full-duplex operation
100half - Supports 100 Mbps half-duplex operation
10full - Supports 10 Mbps full-duplex operation
10half - Supports 10 Mbps half-duplex operation
flowcontrol - Supports flow control
symmetric (Gigabit only) - When specified, the port transmits and
receives pause frames; when not specified, the port will
auto-negotiate to determine the sender and receiver for asymmetric
pause frames. (The current switch ASIC only supports symmetric pause
frames.)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#

Table of Contents

Related product manuals