A
DDRESS
T
ABLE
C
OMMANDS
3-99
Address Table Commands
These commands are used to configure the address table for filtering
specified addresses, displaying current entries, clearing the table, or setting
the aging time.
Priority for
untagged traffic
Indicates the default priority for untagged frames (page
3-189).
Gvrp status Shows if GARP VLAN Registration Protocol is enabled or
disabled (page 3-140).
Allowed Vlan Shows the VLANs this interface has joined, where “(u)”
indicates untagged and “(t)” indicates tagged (page 3-129).
Forbidden Vlan Shows the VLANs this interface can not dynamically join via
GVRP (page 3-130).
Command Function Mode Page
mac-address-table
static
Maps a static address to a port in a VLAN GC 3-101
show
mac-address-table
Displays entries in the bridge-forwarding
database
PE 3-102
clear
mac-address-table
dynamic
Removes any learned entries from the
forwarding database
PE 3-103
mac-address-table
aging-time
Sets the aging time of the address table GC 3-103
show
mac-address-table
aging-time
Shows the aging time for the address table PE 3-105
Field Description
To Next Page
Loading...
Need help?
General
