SMC Networks 6724AL2 User Manual

P RIORITY C OMMANDS
3-189
switchport priority default
Use this command to set a priority for incoming untagged frames. Use the
no form to restore the default value.
Syntax
switchport priority default default-priority-id
no switchport priority default
default-priority-id - The priority number for untagged ingress traffic.
The priority is a number from 0 to 7. Seven is the highest priority.
Default Setting
The priority is not set, and the default value for untagged frames
received on the interface is zero.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
• The default priority applies for an untagged frame received on a port
set to accept all frame types (i.e, receives both untagged and tagged
frames). This priority does not apply to IEEE 802.1Q VLAN tagged
frames. If the incoming frame is an IEEE 802.1Q VLAN tagged frame,
the IEEE 802.1p User Priority bits will be used.
map ip dscp Enables IP DSCP class of service mapping GC 3-200
map ip dscp Maps IP DSCP value to a class of service IC 3-201
show map ip port Shows the IP port map PE 3-202
show map ip
precedence
Shows the IP precedence map PE 3-203
show map ip dscp Shows the IP DSCP map PE 3-204
Command Function Mode Page

SMC Networks 6724AL2 Specifications

General

Brand	SMC Networks
Model	6724AL2
Category	Switch
Language	English