VLAN C
OMMANDS
3-125
switchport acceptable-frame-types
Use this command to configure the acceptable frame types for a port. Use
the no form to restore the default.
Syntax
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
• all - The port accepts all frames, tagged or untagged.
• tagged - The port only passes tagged frames.
Default Setting
All frame types
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When set to receive all frame types, any received frames that are
untagged are assigned to the default VLAN.
Example
The following example shows how to restrict the traffic passed on port 1
to tagged frames:
Related Commands
switchport mode (3-125)
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#
To Next Page
Loading...
Need help?
General
