EasyManua.ls Logo

SMC Networks 6724AL2

SMC Networks 6724AL2
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C
OMMAND
L
INE
I
NTERFACE
3-78
Example
Related Commands
login (3-76)
password-thresh (3-80)
exec-timeout
Use this command to set the interval that the system waits until user input
is detected. Use the no form to restore the default.
Syntax
exec-timeout seconds
no exec-timeout
seconds - Integer that specifies the number of seconds.
(Range: 0 - 65535 seconds; 0: no timeout)
Default Setting
CLI: No timeout
Telnet: 10 minutes
Command Mode
Line Configuration
Command Usage
If user input is detected within the timeout interval, the session is kept
open; otherwise the session is terminated.
This command applies to both the local console and Telnet
connections.
The timeout for Telnet cannot be disabled.
Example
To set the timeout to two minutes, enter this command:
Console(config-line)#password 0 secret
Console(config-line)#
Console(config-line)#exec-timeout 120
Console(config-line)#

Table of Contents

Related product manuals