SMC Networks 6724AL2 User Manual

C OMMAND L INE I NTERFACE
3-64
notifications are sent. In order to configure the switch to send SNMP
notifications, you must enter at least one snmp-server host
command. In order to enable multiple hosts, you must issue a separate
snmp-server host command for each host.
•The snmp-server host command is used in conjunction with the
snmp-server enable traps command. Use the snmp-server
enable traps command to specify which SNMP notifications are
sent globally. For a host to receive notifications, at least one
snmp-server enable traps command and the snmp-server
host command for that host must be enabled.
• The switch can send SNMP version 1 or version 2c traps to a host IP
address, depending on the SNMP version that the management station
supports. If the snmp-server host command does not specify the
SNMP version, the default is to send SNMP version 1 traps.
• However, some notification types cannot be controlled with the
snmp-server enable traps command. For example, some
notification types are always enabled.
Example
Related Commands
snmp-server enable traps (3-66)
snmp-server enable traps
Use this command to enable this device to send Simple Network
Management Protocol traps (SNMP notifications). Use the no form to
disable SNMP notifications.
Syntax
snmp-server enable traps [authentication | link-up-down]
no snmp-server enable traps [authentication |
link-up-down]
• authentication - Keyword to issue authentication failure traps.
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#

SMC Networks 6724AL2 Specifications

General

Brand	SMC Networks
Model	6724AL2
Category	Switch
Language	English