C
OMMAND
L
INE
I
NTERFACE
3-60
Command Mode
Normal Exec, Privileged Exec
Example
SNMP Commands
Controls access to this switch from management stations using the Simple
Network Management Protocol (SNMP), as well as the error types sent to
trap managers.
snmp-server community
Use this command to define the community access string for the Simple
Network Management Protocol. Use the no form to remove the specified
community string.
Console#show calendar set
15:12:34 February 1 2004
Console#
Command Function Mode Page
snmp-server
community
Sets up the community access string to permit
access to SNMP commands
GC 3-62
snmp-server
contact
Sets the system contact string GC 3-63
snmp-server
location
Sets the system location string GC 3-63
snmp-server host Specifies the recipient of an SNMP
notification operation
GC 3-64
snmp-server
enable traps
Enables the device to send SNMP traps
(i.e., SNMP notifications)
GC 3-66
show snmp Displays the status of SNMP communications NE,
PE
3-67
To Next Page
Loading...
Need help?
General
