EasyManua.ls Logo

SMC Networks 6724AL2

SMC Networks 6724AL2
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
M
ULTICAST
F
ILTERING
C
OMMANDS
3-211
ip igmp snooping query-interval
Use this command to configure the query interval. Use the no form to
restore the default.
Syntax
ip igmp snooping query-interval seconds
no ip igmp snooping query-interval
seconds - The frequency at which the switch sends IGMP host-query
messages. (Range: 60-125)
Default Setting
125 seconds
Command Mode
Global Configuration
Example
The following shows how to configure the query interval to 100 seconds:
ip igmp snooping query-max-response-time
Use this command to configure the snooping report delay. Use the no
form of this command to restore the default.
Syntax
ip igmp snooping query-max-response-time seconds
no ip igmp snooping query-max-response-time
seconds - The report delay advertised in IGMP queries. (Range: 5-30)
Default Setting
10 seconds
Command Mode
Global Configuration
Console(config)#ip igmp snooping query-interval 100
Console(config)#

Table of Contents

Related product manuals