F
LASH
/F
ILE
C
OMMANDS
3-23
dir
Use this command to display a list of files in flash memory.
Syntax
dir [boot-rom | config | opcode [:filename]]
The type of file or image to display includes:
• boot-rom
- Boot ROM (or diagnostic) image file
• config - Switch configuration file
• opcode - Run-time operation code image file.
• filename - Name of the file or image. If this file exists but contains
errors, information on this file cannot be shown.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• If you enter the command dir without any parameters, the system
displays all files.
• File information is shown below:
Column Heading Description
file name The name of the file.
file type File types: Boot-Rom, Operation Code, and
Config file.
startup Shows if this file is used when the system is started.
size The length of the file in bytes.
To Next Page
Loading...
