SMC Networks 6724AL2

GVRP AND B RIDGE E XTENSION C OMMANDS
3-139
switchport gvrp
Use this command to enable GVRP for a port. Use the no form to disable
it.
Syntax
switchport gvrp
no switchport gvrp
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
show gvrp configuration
Use this command to show if GVRP is enabled.
Syntax
show gvrp configuration [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
Shows both global and interface-specific configuration.
Command Mode
Normal Exec, Privileged Exec
Console(config)#interface ethernet 1/1
Console(config-if)#switchport gvrp
Console(config-if)#