EasyManua.ls Logo

SMC Networks 6724AL2

SMC Networks 6724AL2
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
I
NTERFACE
C
OMMANDS
3-87
speed-duplex
Use this command to configure the speed and duplex mode of a given
interface when autonegotiation is disabled. Use the no form to restore the
default.
Syntax
speed-duplex {1000full | 100full | 100half | 10full |
10half}
no speed-duplex
1000full - Forces 1000 Mbps full-duplex operation
100full - Forces 100 Mbps full-duplex operation
100half - Forces 100 Mbps half-duplex operation
10full - Forces 10 Mbps full-duplex operation
10half - Forces 10 Mbps half-duplex operation
Default Setting
Auto-negotiation is enabled by default.
When auto-negotiation is disabled, the default speed-duplex setting is
100half for 100BASE-TX ports and 1000full for Gigabit Ethernet
ports.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
To force operation to the speed and duplex mode specified in a
speed-duplex command, use the no negotiation command to
disable auto-negotiation on the selected interface.
When using the negotiation command to enable auto-negotiation,
the optimal settings will be determined by the capabilities command.
To set the speed/duplex mode under auto-negotiation, the required
mode must be specified in the capabilities list for an interface.

Table of Contents

Related product manuals