C
OMMAND
L
INE
I
NTERFACE
3-130
Example
The following example shows how to prevent port 1 from being added to
VLAN 3:
show vlan
Use this command to show VLAN information.
Syntax
show vlan [id vlan-id | name vlan-name]
• id - Keyword to be followed by the VLAN ID.
- vlan-id - ID of the configured VLAN. (Range: 1-4094, no leading
zeroes)
• name - Keyword to be followed by the VLAN name.
- vlan-name - ASCII string from 1 to 32 characters.
Default Setting
Shows all VLANs.
Command Mode
Normal Exec, Privileged Exec
Example
The following example shows how to display information for VLAN 1:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport forbidden vlan add 3
Console(config-if)#
Console#show vlan id 1
VLAN Type Name Status Ports/Channel groups
---- ------- ----------- ------ ------------------------------------
1 Static DefaultVlan Active Eth1/1 Eth1/2 Eth1/3 Eth1/4 Eth1/5
Eth1/6 Eth1/7 Eth1/8 Eth1/9 Eth1/10
Eth1/11 Eth1/12 Eth1/13 Eth1/14 Eth1/15
Eth1/16 Eth1/17 Eth1/18 Eth1/19 Eth1/20
Eth1/21 Eth1/22 Eth1/23 Eth1/24
Console#
To Next Page
Loading...
Need help?
General
