EasyManua.ls Logo

SMC Networks 6724AL2

SMC Networks 6724AL2
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C
OMMAND
L
INE
I
NTERFACE
3-144
Mirror Port Commands
This section describes how to mirror traffic from a source port to a target
port.
port monitor
Use this command to configure a mirror session. Use the no form to clear
a mirror session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
interface - ethernet unit/port (source port)
- unit - Switch (unit 1).
- port - Port number.
rx - Mirror received packets.
tx - Mirror transmitted packets.
both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is
for both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
Command Function Mode Page
port monitor Configures a mirror session IC 3-145
show port
monitor
Shows the configuration for a mirror port PE 3-146

Table of Contents

Related product manuals