EasyManua.ls Logo

SMC Networks 6724AL2

SMC Networks 6724AL2
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C
OMMAND
L
INE
I
NTERFACE
3-68
ip address
Use this command to set the IP address for the currently selected VLAN
interface. Use the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
ip-address - IP address
netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
bootp - Obtains IP address from BOOTP.
dhcp - Obtains IP address from DHCP.
Default Setting
DHCP is enabled by default.
Command Mode
Interface Configuration (VLAN)
Command Function Mode Page
ip address Sets the IP address for the current interface IC 3-69
ip dhcp restart Submits a BOOTP or DCHP client request PE 3-70
ip
default-gateway
Defines the default gateway through which an
in-band management station can reach this
device
GC 3-71
show ip
interface
Displays the IP settings for this device PE 3-72
show ip
redirects
Displays the default gateway configured for this
device
PE 3-73
ping Sends ICMP echo request packets to another
node on the network
NE,
PE
3-73

Table of Contents

Related product manuals