SMC Networks 6724AL2 User Manual

C OMMAND L INE I NTERFACE
3-74
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to
set communication parameters for the serial port or Telnet (i.e., a virtual
terminal).
line
Use this command to identify a specific line for configuration, and to
process subsequent line configuration commands.
Command Function Mode Page
line Identifies a specific line for configuration and
starts the line configuration mode
GC 3-75
login Enables password checking at login LC 3-76
password Specifies a password on a line LC 3-78
exec-timeout Sets the interval that the command interpreter
waits until user input is detected
LC 3-79
password-thresh Sets the password intrusion threshold, which
limits the number of failed logon attempts
LC 3-80
silent-time* Sets the amount of time the management
console is inaccessible after the number of
unsuccessful logon attempts exceeds the
threshold set by the password-thresh
command
LC 3-81
databits* Sets the number of data bits per character that
are interpreted and generated by hardware
LC 3-81
parity* Defines the generation of a parity bit LC 3-82
speed* Sets the terminal baud rate LC 3-83
stopbits* Sets the number of the stop bits transmitted per
byte
LC 3-84
show line Displays a terminal line's parameters NE,
PE
3-84
* These commands only apply to the serial port.

SMC Networks 6724AL2 Specifications

General

Brand	SMC Networks
Model	6724AL2
Category	Switch
Language	English