C
OMMAND
L
INE
I
NTERFACE
3-122
vlan
Use this command to configure a VLAN. Use the no form to restore the
default settings or delete a VLAN.
Syntax
vlan vlan-id [name vlan-name] media ethernet [state {active |
suspend}]
no vlan vlan-id [name | state]
• vlan-id - ID of configured VLAN. (Range: 1-4094, no leading zeroes)
• name - Keyword to be followed by the VLAN name.
- vlan-name - ASCII string from 1 to 32 characters.
• media ethernet - Ethernet media type.
• state - Keyword to be followed by the VLAN state.
- active - VLAN is operational.
- suspend - VLAN is suspended. Suspended VLANs do not pass
packets.
Default Setting
By default only VLAN 1 exists and is active.
Command Mode
VLAN Database Configuration
Command Usage
• no vlan vlan-id deletes the VLAN.
• no vlan vlan-id name removes the VLAN name.
• no vlan vlan-id state returns the VLAN to the default state
(i.e., active).
• You can configure up to 255 VLANs on the switch.
To Next Page
Loading...
Need help?
General
