F
LASH
/F
ILE
C
OMMANDS
3-19
Example
This example shows how to quit a CLI session:
Flash/File Commands
These commands are used to manage the system code or configuration
files.
copy
Use this command to move (upload/download) a code image or
configuration file between the switch’s flash memory and a TFTP server.
When you save the system code or configuration settings to a file on a
TFTP server, that file can later be downloaded to the switch to restore
system operation. The success of the file transfer depends on the
accessibility of the TFTP server and the quality of the network connection.
Console#quit
Press ENTER to start session
User Access Verification
Username:
Command Function Mode Page
copy Copies a code image or a switch configuration
to or from flash memory or a TFTP server
PE 3-19
delete Deletes a file or code image PE 3-22
dir Displays a list of files in flash memory PE 3-23
whichboot Displays the files booted PE 3-24
boot system Specifies the file or image used to start up the
system
GC 3-25
To Next Page
Loading...
Need help?
General
