C
ONFIGURING
THE
S
WITCH
2-24
Web – Click System, File, Firmware. Enter the IP address of the TFTP
server, enter the file name of the software to download, select a file on the
switch to overwrite or specify a new file name, then click Transfer from
Server. To start the new firmware, reboot the system via the System, Reset
menu.
If you download to a new destination file, then select the file from the
drop-down box for the operation code used at startup, and click Apply
Changes. To start the new firmware, reboot the system via the System,
Reset menu.
CLI – Enter the IP address of the TFTP server, select “config” or
“opcode” file type, then enter the source and destination file names, set the
new file to start up the system, and then restart the switch.
Console#copy tftp file 3-19
TFTP server ip address: 10.1.0.99
Choose file type:
1. config: 2. opcode: <1-2>: 2
Source file name: LEO_X_SMC_V2042.bix
Destination file name: LEO_X_SMC_V2042.bix
/
Console#config
Console(config)#boot system opcode: LEO_X_SMC_V2042.bix 3-25
Console(config)#exit
Console#reload 3-16
To Next Page
Loading...
Need help?
General
