Spectracom SecureSync 1200 - Page 175

To add a new entry to the Reference Status table:
1.
Navigate to the Configure Reference Priorities screen via MANAGEMENT > OTHER:
Reference Priority.
2.
Click the PLUS icon in the top right-hand corner of the Configure Reference Priorities
table.
3.
The Add Reference window will display:
4.
In the Add Reference window, enter:
Priority Level: Assign a priority to the new reference.
Time: Select the time reference.
PPS: Select the PPS reference.
Enabled: Check this box to enable the new reference.
5.
Click Apply or Submit. (Submit will close the window.)
Deleting a Reference Entry
To delete an entry from the Reference Status table:
1.
Navigate to the Configure Reference Priorities screen via MANAGEMENT > OTHER:
Reference Priority.
2.
In the Configure Reference Priorities table click the Delete button on the right-hand side
of the entry you wish to delete.
3.
In the pop-up window that opens click OK to confirm.
Reordering Reference Entries
To reorder the priority of a reference entry:
1.
Navigate to the Configure Reference Priorities screen via MANAGEMENT > OTHER:
Reference Priority.
2.
Click and hold on the item whose priority you wish to reorder.
3.
Drag the item up or down to the desired place.
3.3 Managing References
CHAPTER 3 • SecureSync User Reference Guide Rev. 23
159