13 Safety
2006792 Rev B – 200228
Safety
When installing, operating, and maintaining the JetStream, follow these safety practices.
Warnings
• When unpacking and setting up the JetStream, use proper lifting techniques. Avoid
overreaching and leaning over while handling the printer and accessories. If necessary,
use more than one person to lift and move the printing system.
• While installing, maintaining and operating the JetStream, always wear safety glasses,
latex gloves, and protective clothing such as a laboratory smock.
• Ensure that the electrical power source is properly wired and grounded. The power
source should comply with all safety regulations and codes applicable to the installation
location.
• Turn off and unplug the JetStream while servicing and performing maintenance.
NOTE: Some service and maintenance procedures require the power to be left on.
During such procedures, carefully follow the safety instructions.
• Use only Squid Ink Manufacturing inks and fluids. Failure to follow this directive can
damage the unit and void the warranty.
• The JetStream uses capped Ink and Makeup Containers. Do not open or puncture these
containers in any way other than for normal installation. Failure to follow this directive will
void the warranty.
• Keep all fluids away from open flame and excessive heat. Methyl Ethyl Ketone (MEK),
Ethanol, and Acetone are flammable and can cause health issues. Consult SDS sheet
accompanying fluids and inks purchased for product.
• Avoid prolonged fluid contact with skin. Wash contacted skin with soap and water. Refer
to the SDS sheet accompanying the fluid.
• Do not look directly into the Printhead. If fluids make eye contact, flush immediately with
water and seek medical attention.
• Never pour fluids into a sink, sewer, or drain. Dispose of fluids in accordance with all
ordinances and regulations pertaining to hazardous fluid disposal.
To Next Page
Loading...
