CYLINDER HEAD, CYLINDER AND PISTON 6-31
CAM CHAIN TENSION ADJUSTER
• Retract the push rod by pushing the stopper
1.
• Apply SUZUKI SUPER GREASE to the O-ring
2.
( 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Install the cam chain tension adjuster
3 as shown.
• Tighten the cam chain tension adjuster mounting bolts to the
specified torque.
$ Cam chain tension adjuster mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the spring
4 and bar
5.
• Install the gasket
6 and cam chain tension adjuster cap bolt
7.
NOTE:
Click sound is heard when the cam chain tension adjuster cap
bolt is installed.
• Tighten the cam chain tension adjuster cap bolt to the speci-
fied torque.
$ Cam chain tension adjuster cap bolt:
23 N·m (2.3 kgf-m, 16.5 lb-ft)
CAUTION
Use a new O-ring
2 prevent oil leakage.
Upward
CAUTION
After installing the cam chain tension adjuster, check
to be sure that the adjuster works properly by check-
ing the slack of cam chain.
To Next Page
Loading...
