9-6 GEARSHIFTING
• Apply a small quantity of THREAD LOCK to the gearshift cam
driven pin
6 and tighten it to the specified torque.
% 99000-32050: THREAD LOCK “1342”
$ Gearshift cam driven pin: 24 N·m (2.4 kgf-m, 17.5 lb-ft)
• Fit the springs
7, pins
8 and pawls
9 to the gearshift cam
driven gear
0. Wider side
C of pawl should be positioned
outside.
• With the pawls held in pushed position, install the pawl lifter
A.
• Apply THREAD LOCK SUPER to the pawl lifter screws and
tighten them.
# 99000-32030: THREAD LOCK SUPER “1303”
To Next Page
Loading...
