17-14 FRONT FORK AND STEERING
• With the damper rod in horizontal position, move the inner rod
by hand to inspect it if operating smoothly.
• If the inner rod is not extend, repeat the “COMPRESSION
DAMPER UNIT” procedures (Pour the specified amount fork
oil and discharge an excess of oil). (!17-12)
• Make sure approx. 10 mm (0.39 in) of inner rod thread is
exposed on the end.
• Completely wipe off the fork oil from the spring and damper
rod assembly.
• Apply fork oil to the bushing
7.
• Insert the spring and damper rod assembly into the fork.
• Temporarily tighten the fork cap bolt (sub-tank).
100 mm
(3.9 in)
Approx.10 mm
(0.39 in)
Lock-nut
To Next Page
Loading...
