TANDBERG evolution 5000 E5710 - Data XB - RS422 Menu (M2;EOM2;DAT Fitted); Hardware Release Option; Overview; RS232 PID Option

Operating the Equipment Locally
Page 4-70 Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
RS232 PID Option
The RS232 PID option is selected from the Data XA - RS232 Menu by
pressing the RS232 PID softkey. The option is used for entering or
updating data PIDs. Enter a PID using the softkeys, then press the Enter
softkey to accept it.
To be DVB compliant, PIDs below 32 are reserved. Therefore PIDs 32 to
8191 are available for use. In the event of a clash, one of the PIDs will be
changed by the Encoder’s internal checking algorithm.
RS232 PID
¬ Left RS232 Data PID : +
® Right `262 (0106h)’ —
l Ins Enter l
l Del Update using softkeys Quit l
Hardware Release Option
This option indicates the hardware release of the data card. It is for status
only and cannot be changed.
Software Release Option
This option indicates the software release of the data card. It is for status
only and cannot be changed.
4.10.4 Data XB – RS422 Menu (M2/EOM2/DAT Fitted)
Overview
See Section 4.10.2, Data B - RS422 Menu for the following options:
· Encoding
· Bit-rate
· RS422 PID
Hardware Release Option
This option indicates the hardware release of the data card. It is for status
only and cannot be changed.
Software Release Option
This option indicates the software release of the data card. It is for status
only and cannot be changed.