TANDBERG evolution 5000 E5710 - Keypress Beep Option; Power Dip Recovery Option

Operating the Equipment Locally
Page 4-26 Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
Table 4.15: Screen Saver Options
Selected Option Description
Top Level Menu
Van
TANDBERG
Service Name
Off
If no changes have been made to the Encoder for five
minutes (no softkey has been pressed) the chosen screen
saver appears on the front panel display.
Keypress Beep Option
To access the Keypress Beep option, press the Keypress Beep softkey in
the General Menu.
Keypress Beep
Beep when Key Pressed : +
Off —
Enter l
Update using softkeys Quit l
Table 4.16: Keypress Beep Options
Selected Option Description
On A beep sounds every time that a key is pressed.
Off There is silence every time that a key is pressed.
Power Dip Recovery Option
NOTE…
This may not affect stand-alone Encoders, only those with a modulator option fitted.
To access the Power Dip Recovery option, press the Power Dip Recovery
softkey in the General Menu.
Power Dip Recovery
Restore Outputs Following a Power Dip : +
Off —
Enter l
Update using softkeys Quit l
Table 4.17: Power Dip Recovery Options
Selected Option Description
On The outputs are restored following a power dip.
Off The outputs are not restored following a power dip.