TANDBERG evolution 5000 E5710 - Current Password Option; Display Errors Option; Setup Password Option; System Control Option

Operating the Equipment Locally
Page 4-28 Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
Setup Password Option
There is no password originally required to edit parameters so if one is
needed then it must be set. To access the Setup Password option, press
the Setup Password softkey in the Advanced Menu. The password can be
either on or off.
Current Password Option
To access the Current Password option, press the Current Password
softkey in the Advanced Menu. This allows the current password to be
changed.
NOTE…
For forgotten passwords, contact Customer Services.
Current Password
¬ Left Enter Password : +
® Right `0123456789’ —
l Ins Enter l
l Del Update using softkeys Quit l
Display Errors Option
To access the Display Errors option, press the Display Errors softkey in
the Advanced Menu. This displays or hides relevant error messages
according to whether the option is set On or Off.
System Control Option
To access the System Control option press the System Control softkey in
the Advanced Menu. This option enables the type of system control
specified in the SI to be set.
System Control
System Control : +
MEM —
Enter l
Update using softkeys Quit l
Table 4.19: System Control Options
Selected Option Description
MEM Control of the video/audio delay (lip sync) is via the MEM.
Local Control of the video/audio delay (lip sync) is within the
Encoder
1
.
External (SNMP) Control of the video/audio delay (lip sync) is via the SNMP
protocol.
1
To ensure correct lip sync when working with linear or pre-encoded audio, the option card M2/EOM2/AUDLIN should
be used.