TANDBERG evolution 5000 E5710 - Reset Encoder Option; Reset on Download Option; Build Menu; Video Menu

Operating the Equipment Locally
Page 4-30 Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
If the background is set to very dark or very light, the text may not be
visible. In this instance, view the display at an acute angle, this should
enable the text to be seen enough to change the contrast.
Reset On Download Option
To access the Reset On Download option, press the Reset On Download
softkey in the Advanced Menu. the option can be Yes or No. If Yes, the
Encoder automatically reboots following a download, keeping the current
configuration. If No, the Encoder keeps working normally.
Reset Encoder Option
To access the Reset Encoder option, press the Reset Encoder softkey in
the Advanced Menu. A confirmation message appears “Reset Encoder –
Are you sure?”. If Yes is selected the Encoder immediately reboots,
keeping the current configuration. If No, the Encoder keeps working
normally.
CAUTION…
The Reset Encoder option is not normally used.
One example of its use is when code has been downloaded in background mode (such as Base Board
code or Video Compression Module (VCM) code) and you want to reset the Encoder, to action the new
code.
4.7.7 Build Menu
The Build Menu is selected from the System Menu by pressing the Build
softkey. The Build Menu shows the status of the options shown in
Figure 4.9. They cannot be changed.
4.8 Video Menu
4.8.1 Introduction
The Video Menu is selected from the Setup Menu by pressing the Video
softkey. This menu permits the selection of video parameters. Any option
with a clear circle next to it cannot be accessed and changed. It is for
status information only (see Figure 4.10 for menu structure).
4.8.2 Video Source Menu
Overview
The Video Source Menu is selected from the Video Menu by pressing the
Video Source softkey. This menu permits the selection of video source
parameters. The screens vary according to the type of video source
selected.
Video Input Option
To access the Video Input option, press the Video Input softkey from the
Video Source Menu.