Technical Specification
Instruction Manual: evolution 5000 E5710 and E5720 Encoder Page B-13
ST.TM.E10074.1
B.8.2 EMC
2
The equipment has been designed and tested to meet the following:
EN 55022
and
AS/NZS 3548
European
Australia and
New Zealand
Emission Standard
Limits and methods of measurement of
radio frequency interference
characteristics of information
technology equipment - Class A.
EN 61000-3-2
3
European Electromagnetic Compatibility (EMC),
Part 3 Limits; Section 2. Limits for
harmonic current emissions (equipment
input current £ 16 A per phase).
EN 61000-3-3
3
European Electromagnetic Compatibility (EMC),
Part 3. Limits; Section 3. Limitation of
voltage fluctuations and flicker in low
voltage supply systems for equipment
with rated current £ 16 A.
EN 55024:1998 European Information technology equipment -
Immunity characteristics - Limits and
methods of measurement.
FCC USA Conducted and radiated emission limits
for a Class A digital device, pursuant to
the Code of Federal Regulations (CFR)
Title 47-Telecommunications, Part 15:
Radio frequency devices, subpart B -
Unintentional Radiators.
B.8.3 CE Marking
The CE mark is affixed to indicate compliance with the following
directives:
89/336/EEC of 3 May 1989 on the approximation of the laws of
the Member States relating to electromagnetic compatibility.
73/23/EEC of 19 February 1973 on the harmonisation of the
laws of the Member States relating to electrical equipment
designed for use within certain voltage limits.
NOTE...
The CE mark was first affixed to this product in 2001.
2
The EMC tests were performed with the Technical Earth attached, and configured using recommended cables (see
Table B.20).
3
Applies only to models of the Encoder using ac power sources.
To Next Page
Loading...
