TANDBERG evolution 5000 E5710 - Page 203

Predefined User Configurations
Instruction Manual: evolution 5000 E5710 and E5720 Encoder Page C-3
ST.TM.E10074.1
C.1 Introduction
There are sixteen predefined user configurations. These are a quick and
easy way to configure the Encoder without having to enter individual
parameters.
C.2 525/625 Line Default Settings
Table C.1: 525/625 Line Default Settings
Lines Frame Rate GOP Length
525 29.97 Hz 15
625 25 Hz 12
C.3 General Default Settings
The Encoder parameters and default settings are as shown in Table C.2.
Table C.2: Default Configuration Settings
Module Parameter Default Value
System: UTC Offset 0
Config Name Config Name
Screen Saver Off
Screen Saver Delay 300 s
Key Beeper On
Power Dip Recovery Off
Fan Control Auto (Temp. Controlled)
Service Name Default Service
Service Provider Service Provider
Network Name TANDBERG
Syntax DVB
Network Id 0xFFFF
Service Id 1
Transport Stream Id 1
PMT PID 0x20
ATSC Program 2
SI Level On (DVB compliant)
PSIP Source (ATSC) BNC 1
PSIP Min PID 0x1FD0
PSIP Max PID 0x1FFE
Logical Channel Descriptor Off
Logical Channel 1
Logical Channel Descriptor Id 0x83