Tormach PCNC 440 - Page 15

Chapter 1
15
UM10372_PCNC440_Manual_0221A
PREFACE
7.4.2 Cancel Acve Canned Cycle – G80 131
7.4.3 Simple Drilling Cycle – G81 132
7.4.4 Simple Drilling Cycle (dwell) – G82 134
7.4.5 Peck Drilling Cycle – G83 134
7.4.6 Boring Cycle (feedrate out) – G85 134
7.4.7 Boring Cycle (dwell, rapid out) – G86 135
7.4.8 Boring Cycle (dwell, manual out) – G88 135
7.4.9 Boring Cycle (dwell, feedrate out) – G89 135
7.5 Built-in M-codes 136
7.5.1 Program Stop and Program End – M00, M01, M02, and M30 136
7.5.2 Spindle Control – M03, M05 137
7.5.3 Tool Change – M06 137
7.5.4 Coolant Control – M07, M08, and M09 137
7.5.5 Override Control – M48, M49 138
7.5.6 Feed Override Control – M50 138
7.5.7 Spindle Speed Override Control – M51 138
7.5.8 Set Current Tool Number – M61 138
7.5.9 Set Output State – M64, M65 139
7.5.10 Wait on Input – M66 140
7.6 Other Input Codes 140
7.6.1 Feed Rate – F 140
7.6.2 Spindle Speed – S 140
7.6.3 Change Tool Number – T 141
7.7 Advanced Programming with Parameters and Expressions 141
7.7.1 Parameters 141
7.7.2 Parameter Types 143
7.7.2.1 Numbered Parameters 143