Tormach PCNC 440 - Page 14

Chapter 1
14
UM10372_PCNC440_Manual_0221A
PREFACE
7.3.5.3 Set Tool Table – G10 L10 116
7.3.5.4 Set Tool Table – G10 L11 117
7.3.5.5 Set Coordinate System – G10 L20 117
7.3.6 Plane Selecon – G17, G18, and G19 118
7.3.7 Length Units – G20, G21 118
7.3.8 Return to Pre-dened Posion – G28, G28.1 118
7.3.9 Return to Pre-dened Posion – G30, G30.1 119
7.3.10 Straight Probe – G38.x 119
7.3.10.1 Using the Straight Probe Command 120
7.3.11 Cuer Compensaon – G40, G41, and G42 121
7.3.11.1 Cuer Compensaon O – G40 121
7.3.11.2 Cuer Compensaon On – G41, G42 122
7.3.12 Dynamic Cuer Compensaon – G41.1, G42.1 122
7.3.13 Apply Tool Length Oset – G43 123
7.3.14 Engrave Sequenal Serial Number – G47 124
7.3.15 G49 Cancel Tool Length Compensaon – G49 124
7.3.16 Absolute Coordinates – G53 125
7.3.17 Select Work Oset Coordinate System – G54 to G59.3 125
7.3.18 Set Exact Path Control Mode – G61 125
7.3.19 Set Blended Path Control Mode – G64 126
7.3.20 Distance Mode – G90, G91 126
7.3.21 Arc Distance Mode – G90.1, G91.1 126
7.3.22 Temporary Work Osets – G92, G92.1, G92.2, and G92.3 127
7.3.23 Feed Rate Mode – G93, G94, and G95 127
7.3.24 Spindle Control Mode – G96, G97 128
7.4 Canned Cycles 129
7.4.1 High Speed Peck Drilling Cycle – G73 131