Tormach PCNC 440 - Installation

Chapter 1
9
UM10372_PCNC440_Manual_0221A
PREFACE
3.3.5 X-axis Motor Cover Plate 27
3.3.6 X-axis Limit Switch Cover Plate 27
3.3.7 Manual Oiler 27
3.3.8 Flood Coolant System 27
3.3.9 Install the Monitor 28
3.3.10 Install the PathPilot Controller 28
3.4 Essenal Controls Overview 30
3.4.1 E-stop, Start, Reset, and Main Disconnect 30
3.5 Power O/Power On Procedure 31
3.6 Inial PathPilot Controller Conguraon 32
3.7 Validate Basic Installaon 33
3.7.1 Verify Limit Switch Funcon 33
3.7.2 Verify Axis Funcon 34
3.7.3 Verify Spindle Funcon 34
3.7.4 Installaon Troubleshoong 34
3.8 Controller Customizaon 35
4. Operaon 36
4.1 Control Locaons 36
4.1.1 Operator Box 36
4.1.2 PathPilot Interface 36
4.1.3 Accessory Port 37
4.2 Inializing the Mill 37
4.2.1 Vital Reference 37
4.3 Jogging 37
4.3.1 Keyboard 37
4.3.2 Jog Shule 38
4.4 Spindle Controls 38